Anti-Trap functie

[Japiejo5]

Heb een melding ANTI-TRAP functie uitgeschakelt.

Nu weet ik inmiddels dat dit de beveilging is van de elektrische ramen.

Iemand enig idee hoe ik dit kan resetten???

Op een amerikaanse site heb ik onderstaande stappenplan gevonden,..maar biedt bij mij helaas geen uitkomst.

Wellicht is dit specifiek voor amerikaasne series?

Finally got my window to reset! This is the process that I followed. The BMW instructions didn't work.

1. Start the car. Key in position "on" did not work for me.
2. At the window that is having the problem, lower the window all the way down (open) and then release the switch.
Don't do step 2 from the driver's seat. Do it at the window that is having problems.
You will know which window has problems because the "one-touch" function doesn't work.
3. After the window is fully down, push the switch all the way down (to position 2 or one-touch open position) and hold for 20 seconds.
4. Then immediately pull the switch up to position 2 (one-touch close position) and hold. Do not let go (even if the window stops after a few inches of going up)
5. Wait until the anti-trap message on the display disappears.

The symptoms I had were:
a. One-touch open/close did not work on the problem window.
b. The window only opened/closed 4 inches at a time even if you held the button down/up.
c. Anti-trap message appears on the console every time I started the car.

[bajjou]

Hoi

heb die beschijving gevolgd en bij mijn is het wel gelukt de melding is weg uit mijn boardcomputer en de raam werkt weer als van ouds.

Heel erg bedankt voor die beschrijving.

Mo